I have been looking for a good sub $50 theromemter that would work best for mashing but still have all around use. I found a thread were someone said they have good luck with the DT400. It is $20 + shipping and the specs rival the thermapen with accuracy at 0.5 C / 1.0F. Does anyone else use this thermometer? I have yet to find a bad review on it and everyone seems to say the temp is spot on
http://www.comarkltd.com/product.tpl?product_id=424
Waterproof
Response time better than 6 seconds
°F/°C switchable
Maximum temperature hold
Field Calibratable
Auto power off
NSF
BioCote® antimicrobial protection
http://www.comarkltd.com/product.tpl?product_id=424
Waterproof
Response time better than 6 seconds
°F/°C switchable
Maximum temperature hold
Field Calibratable
Auto power off
NSF
BioCote® antimicrobial protection