Tri clamp fitting for brewmometer

Hello
Does anyone know of a vendor that makes a tri clover thermowell that a Blichmann Brewmometer could screw or at least be set into? I have a 10 gallon blichmann that I changed to a thermowell to run off a controller. I want to put my brewmometer on my new kettle which has a 1 inch tri clover ferrule. If anyone has any ideas it would be much appreciated.

Thanks

Brewers Hardware has some thermowells that might work for you.
https://www.brewershardware.com/Tri-Clover-Thermowells/

If you just want the brewmometer to go straight in without a thermowell, you could also use something like this if your thermometer has 1/2" male NPT.
https://www.brewershardware.com/1.5-Tri-Clover-X-1-2-Female-BSPP.html

That is what I thought brewer's hardware has the 1/2 female PT. Online the brewmometer states it has a 1/2"-20 UNF thread. So are these compatible?

1/2"-20 is is a fine thread pitch. The threads are straight and there are 20 threads per inch or TPI. Coincidentally you will see TPI on saw blades but that means teeth per inch.

The Brewer's Hardware adapter is a pipe thread. 1/2" NPT, or national pipe thread, has 14 TPI and has a tapered thread. You could probably thread them together good enough to make a seal but you would ruin both parts in the process.

Okay thanks good to know. I will keep looking around thanks for the help.