3 Gauge Regulater with 1 gauge that stopped working.

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

garcara

Well-Known Member
Joined
Mar 22, 2011
Messages
101
Reaction score
4
Location
Seattle
Hi, I have a 3 gauge regulator and the one furthest from where the co2 comes in is not letting any co2 through. Any ideas?
 
Assuming you have already tried adjusting the output pressure on that regulator, I would try removing the nipple (check valve) from bottom of regulator. There will be a rubber seal to check and Clean and push on the little SS ball inside to exercise the spring.

Someone else might know more but that should give you something to start with.
 
Back
Top