ElevenBrewCo
Well-Known Member
Wondering if anybody has cut there welds in there sanke setups to go to weldless fittings. I was shafted by a fab shop because they "apperantley" ss welded my fittings, but the rust on the welds says other wise.
Talking to our welders at work, there is no fixing the rust as it will keep comming back over time if i try and fix it. Its going to be a pain to try and cut the welds off my fittings as i only have a grinder. Is it worth it? or can i try another solution.
I hoping to get bobbys ss weldless fittings if i do decide to cut them.
Thoughts?
Talking to our welders at work, there is no fixing the rust as it will keep comming back over time if i try and fix it. Its going to be a pain to try and cut the welds off my fittings as i only have a grinder. Is it worth it? or can i try another solution.
I hoping to get bobbys ss weldless fittings if i do decide to cut them.
Thoughts?