stdywell
Well-Known Member
I picked up a BM23 yesterday. The compressor fan runs and the inside fan runs. this thing has not been used or turned on in a year. Based on the numbers on the Tecumseh compressor, it appears to have been made in 2001. I plan on letting it sit for a good day or so before firing it up again after transport. ( Had to tilt it to get it into my van and it went on its back for a few seconds)
My question is this: how long should I leave it on for to determine if it is going to get cold or not ? ( I only had a couple minutes to check it out and just made sure it was electrically sound )
Any help would be appreciated.
Thanks all,
Doug
My question is this: how long should I leave it on for to determine if it is going to get cold or not ? ( I only had a couple minutes to check it out and just made sure it was electrically sound )
Any help would be appreciated.
Thanks all,
Doug