Safe to drill inside the 4912?

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

capcrnch

Well-Known Member
Joined
Jul 10, 2007
Messages
865
Reaction score
13
Location
Meeeechigan
I'd like to mount my CO2 distributor inside on my 4912...
Am I safe to put 4 small screws (siliconed) in there or is that area riddled with freon lines as well?

I'd like to mount this on the back wall of the fridge, up somewhat high on the wall...

A pic of the distributor in question..

AirDist,%202%20way_thumb.jpg


Thanks!
 
lol... I think you may be on your own on that one. I'd seriously consider gluing a small piece of wood to the side and drilling into that. You *probably* wont hit anything, then again if you do you blew the whole thing.
 
That's my fear.. Ruining it all over a distributor.

I know I saw some pictures on here where a couple of guys mounted it to the inside, but after an hour of searching 4912 pictures, I gave up.
 
Not to hi jack the thread or anything, but...
My 4912 is in the garage and set at 3 or 4 and the back panel keeps frosting up. Is that normal, or do I have an issue to deal with?
 
Back
Top