Disassembling the regulator
- Thread starter levon15
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
samc
Well-Known Member
Use a small amount of dish soap and water to check for leaks. How would taking it apart help you determine if it is leaking? I wouldn't take it apart, and generally I can't think of what part you would use teflon tape on.
Where the gauges screw into the regulator and where the on/off gas out valve screws into the regulator.
I will check with dish soap but its an older used setup so I suspect a leak and wanted to get feedback on what to use to repair if needed.
I will check with dish soap but its an older used setup so I suspect a leak and wanted to get feedback on what to use to repair if needed.
samc
Well-Known Member
OK, I would use some pipe dope instead of tape for those connections. I think it does a better job. They have a newer Teflon based version.
