mbeattie
Well-Known Member
Is there any problem using a ball valve labeled for gas and not water on my mash tun? I could only find valves the right size that were labeled 'gas' and after putting it together it seems to work just fine.
Ball valve
- Thread starter mbeattie
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
subwyking
Well-Known Member
it shouldn't be a problem. im assuming your talking about a brass ball valve. the only thing you need to keep in mind, is that brass has a small amount of surface lead. you can easily remove this by soaking the valve in a hydrogen peroxide/white vinegar solution for about ten minutes. if the solution starts to go green, dump it and pour some fresh stuff in.
Similar threads
Latest posts
-
-
-
-
is there a real substitute for llalemand kolsch yeast- Latest: Draft Master Flash
-
-
-
