I am working on re-doing my small brew area and moving up to 20 gallons.
I am working on a design using Mcmaster slotted angle parts
http://www.mcmaster.com/#slotted-stainless-steel-angles/=gmqx0e
First, is 4664T21 overkill and I can just get away with the smaller 4664T18
(if you look at the site these numbers will make sense). I will be anchoring this to the wall and the floor.
I will of course be adding in the corner plates. I did not add them in until I am happy with the design. I also will put in a piece of 3/4 plywood or MDF under each pot.
More questions. does the bottom kettle have enough clearance?
Should I add in a center piece for each pot so it can rest on that?
Would the "empty" square be a good spot to add shelves in for bins?
The model for the Pots came with a bottom port. Should I put in a bottom one, or go with the traditional side port?
Sketchup Pic.
I am working on a design using Mcmaster slotted angle parts
http://www.mcmaster.com/#slotted-stainless-steel-angles/=gmqx0e
First, is 4664T21 overkill and I can just get away with the smaller 4664T18
(if you look at the site these numbers will make sense). I will be anchoring this to the wall and the floor.
I will of course be adding in the corner plates. I did not add them in until I am happy with the design. I also will put in a piece of 3/4 plywood or MDF under each pot.
More questions. does the bottom kettle have enough clearance?
Should I add in a center piece for each pot so it can rest on that?
Would the "empty" square be a good spot to add shelves in for bins?
The model for the Pots came with a bottom port. Should I put in a bottom one, or go with the traditional side port?
Sketchup Pic.