gator_brewer
Well-Known Member
So I'm working on building my first mash tun and I ran into a small problem.
I installed the ball valve and fittings and everything and it's water tight. However, it's not secured, I can easily rotate it. Not sure if this is a big deal or not.
My thoughts are just adding a layer of liquid nails to the outside of the ball valve to help secure it. I figure the outside will mean it doesn't touch the liquid, so it doesn't matter if it is food safe.
Does that sound like a good plan, or does someone have something better?
Thanks
I installed the ball valve and fittings and everything and it's water tight. However, it's not secured, I can easily rotate it. Not sure if this is a big deal or not.
My thoughts are just adding a layer of liquid nails to the outside of the ball valve to help secure it. I figure the outside will mean it doesn't touch the liquid, so it doesn't matter if it is food safe.
Does that sound like a good plan, or does someone have something better?
Thanks