Dissecting small fridge for parts

I want to make a kegerator, but I also want to build it into a bookshelf. (Essentially, a cabinet below for the kegerator, and shelves above). Using the Sanyo 4912 would make it very deep for a bookshelf, so I wanted to make it thinner ... basically just deep enough to have 2 kegs and a CO2 tank side by side.

Is there any way to dissect a small 1.7 cubic foot refirgerator, and use those parts to create custom sized refrigerator using some insulation from Home Depot? Or am I getting in way over my head with this idea? Also, am I going to be able to get much thinner between the thickness of the kegs and all the insulation that I'll need?

Any help would be greatly appreciated.

This thread had a bunch of ideas along the same lines. It isn't a full out kegerator, but it does have some good designs that may serve as a starting point for yout project.

https://www.homebrewtalk.com/showthread.php?t=54562

More help here:
https://www.homebrewtalk.com/showthread.php?t=35125