WTB: Custom 1/2" SS tubing watering wand

I'm looking for a "hook" so I can hang a recirculating line into the top of by brew pot. I want a section of 1/2" tubing about 18" long with a shepard's crook on the end so it will hang on the edge of the pot. The 180 curve at the top of the wand should be as tight a radius as possible.

I'd love 1/2" stainless NPT threads on the bottom end but if not possible I can take care of that myself with a swagelock. The top I plan to use a piece of 1/2" silcone tubing + clamp to lay down on top of the mash.

Let me know if you can help me out. Thanks.

Check out stainlessbrewing.com

They do custom bent coils, this should be easy for them to do.