ClutchDude
Well-Known Member
Howdy,
I'm setting up to get the rig built this week. I searched in vain of a parts list on here but I've got a good idea of what to build. It will be a thin, three tier with two burners mounted at the top and the bottom (middle is MLT)
My main question, though is that if it's ok to use 1/2" black iron piping for the LP gas feed(all parts are 1/4", haven't seen any 1/4" black iron pipe).
I don't want to use long propane hosing but rather get exact sizes for the piping. Then again, I may stupid in trying that. Either way, what should I use to distribute the propane to tower?
Lastly, those with banjo burners, how far did you mount from the top?
Thanks in advance.
I'm setting up to get the rig built this week. I searched in vain of a parts list on here but I've got a good idea of what to build. It will be a thin, three tier with two burners mounted at the top and the bottom (middle is MLT)
My main question, though is that if it's ok to use 1/2" black iron piping for the LP gas feed(all parts are 1/4", haven't seen any 1/4" black iron pipe).
I don't want to use long propane hosing but rather get exact sizes for the piping. Then again, I may stupid in trying that. Either way, what should I use to distribute the propane to tower?
Lastly, those with banjo burners, how far did you mount from the top?
Thanks in advance.