P-J's simple setup

BrewSwag 728
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
B

Banjoman002

Active Member
Joined
Feb 21, 2012
Messages
44
Reaction score
1
Location
Clarkston
Ok, I've ordered most of the parts for the simple controller set up for my HLT.
My question. Since I'm dealing with a 30 amp 240 volt circuit with incoming power on 10 ga. wire to the terminal strips, Should I continue with 10 ga. wire throughout the build?

Rich
 
See if I can do this...

Auberin-wiring1-a4-4500w-BIAB-30d.jpg
 
Only use 10 on the wire that goes from the incoming power to the element, including the 220 side of the SSR. anything going to the PID is carrying very little, use something like 18 ga. whatever you have close to that.
 
Yes, and follow those all the way back to where they come in to your control box. Like the red wire that comes from the power source and hooks up to the SSR. I cant click on your image and get it any larger to make notes on it. Also the Ground that goes to your 3 prong plug should be 10 or 12 awg.
 

Similar threads

David Coy
Power 1 and/or 2 Anvil Foundries at 240 from a 30 amp 240 spa panel
Replies
4
Views
573
David Coy
David Coy
ALAN C
Need help to confirm wiring .
Replies
17
Views
2K
ALAN C
ALAN C
R
My experience with the Auber Brew Buddy 50-amp kit
Replies
0
Views
1K
RunnyDMC
R
I
SS Brewtech InfuSSion Mash Tun Custom Heater
Replies
7
Views
854
Indian_villager
I
Eaglesbrewer44
Another Electric Panel Build
Replies
35
Views
3K
Eaglesbrewer44
Eaglesbrewer44
InkBird 300

Latest posts

Back
Top