Screwed up my Mash Tun

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

1234

Well-Known Member
Joined
Mar 8, 2009
Messages
1,520
Reaction score
7
Location
Hendersonville, TN
Hey guys I could use some help. I traded a keggle for rubber coated keg that I planned to use as my mash tun. When I went to drill the pilot hole I realized I was a little low so I moved my bit just a bit higher thinking that it would round out into the initial pilot hole. Now I have a hole that has a extra little taken out of the bottom, can you help. I would post a picture but I am not sure how. If I figure it out I will post a picture. :(
 
Depending on how much extra opening you created it might be simpler to buy a larger silicone o-ring and SS washer to cover the over sized hole.
 
Back
Top