Monster Mash
Well-Known Member
After knocking my tap handles open a few times changing out kegs I decided to make tap handles that wouldn't get in the way. I set up my table saw and cut 3 X 4 blocks, drilled holes smaller then the tap threads and just screwed them right onto the taps.
A little clear coat and some new lables and in about an hour I had these made. They are big enough for a lable and short enough to lift kegs over...
A little clear coat and some new lables and in about an hour I had these made. They are big enough for a lable and short enough to lift kegs over...
