I got a 2 tap pin lock keg setup from kegconnection.com during their black friday sale.
I finally got it all hooked up today. I carbed the beer in advance and the kegs all pressurized fine. I hooked up my beer lines to the kegs and they dispensed just fine through the faucets.
I left for a few hours and came back with a river of beer going from my keezer to the floor drain in my basement. Both kegs are leaking from what appears to be the connection from the beer line hose to the adapter that screws into the pin lock connector. I didn't do anything special to the setup except run half a keg of oxy clean water through each side.
The beer tubing looks like it is attached to the pin lock connector by a metal type clamp. I have no way of tightening or loosening this clamp. Has anyone else ever had this problem? I plan on contacting Kegconnections tomorrow but didn't know if this was user error (which I doubt).
I finally got it all hooked up today. I carbed the beer in advance and the kegs all pressurized fine. I hooked up my beer lines to the kegs and they dispensed just fine through the faucets.
I left for a few hours and came back with a river of beer going from my keezer to the floor drain in my basement. Both kegs are leaking from what appears to be the connection from the beer line hose to the adapter that screws into the pin lock connector. I didn't do anything special to the setup except run half a keg of oxy clean water through each side.
The beer tubing looks like it is attached to the pin lock connector by a metal type clamp. I have no way of tightening or loosening this clamp. Has anyone else ever had this problem? I plan on contacting Kegconnections tomorrow but didn't know if this was user error (which I doubt).