• If you have bought, sold or gained information from our Classifieds, please donate to HomeBrewTalk and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Immersion Chiller- 50' 1/2" copper

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

cyberbackpacker

Well-Known Member
Joined
Jul 25, 2008
Messages
2,209
Reaction score
499
Location
Holland, MI
I have an immersion chiller made of 50' of 1/2" copper tubing, with 90 degree elbows sweated for the input line.

$35 plus the ride.

3656140882_1411a0f69e_b.jpg
 
No offense, but what did you use as a form, it looks like a slinky that has been run over a few times. :ban:
 
:ban:
Hey a slinky was entertaining for about 2 minutes.

Also, Not to pick on you or anything i promise.
If you make anouther one... Leave a good chunk of copper going up and out so if you have a deep kettle you dont burn your garden hose and spring a leak :drunk:


Plus where is the ends?
Like i said, Not pickin on ya...Just need to do more research and a little bit of practice. :tank:
 
Back
Top