High_Noonan
Well-Known Member
Hi all.
Third AG batch is in the books. Now that I have the technique under control, I am starting to look at tweaking my setup.
Currently, I am using a three tier, non-sculpture, gravity-feed system.
Gravity-feed until it hits the BK ball valve, that is.
I have a Chugger pump and a DudaDiesel 30 plate chiller running from that point to the carboy.
Right now I have a 3" dial thermometer in a tee on the output side of the plate chiller and, well, that huge dial looks kind of goofy. I'd seriously like to reduce the dial size, but I am having a hard time coming up with a source for a 2" dial, 2.5" probe, bimetal thermometer.
Any ideas?
Third AG batch is in the books. Now that I have the technique under control, I am starting to look at tweaking my setup.
Currently, I am using a three tier, non-sculpture, gravity-feed system.
Gravity-feed until it hits the BK ball valve, that is.
I have a Chugger pump and a DudaDiesel 30 plate chiller running from that point to the carboy.
Right now I have a 3" dial thermometer in a tee on the output side of the plate chiller and, well, that huge dial looks kind of goofy. I'd seriously like to reduce the dial size, but I am having a hard time coming up with a source for a 2" dial, 2.5" probe, bimetal thermometer.
Any ideas?