blk94f150
Well-Known Member
I just got my Brew Logic Dual Tap Draft System from Midwest. One of the kegs is missing both post o-rings and all four of the tube o-rings (the o-ring between the post fittings) are pretty worn.
The kegs did come under pressure, so everything must seal well, but I was expecting new O-rings at least.
I've ordered bulk O-rings from McMaster-Carr for all three types, but do you think Midwest should have put new O-rings on the kegs?
I'm debating if I should call them or just say screw it.
Mike
The kegs did come under pressure, so everything must seal well, but I was expecting new O-rings at least.
I've ordered bulk O-rings from McMaster-Carr for all three types, but do you think Midwest should have put new O-rings on the kegs?
I'm debating if I should call them or just say screw it.
Mike