I am going to be picking up a March 809 HS soon and I am wondering what you guys would recommend for fittings, should I go with polypropylene or would it be OK to go with a brass fitting?
Also I have an option here, I can order it from BMW (Which I would prefer) but the input side of the housing is a 3/4" MPT which may be hard to find a fitting to reduce it to a 3/8" barb. The other fitting on the pump is the standard 1/2" MPT on the output. The one that Austin home brew sells has identical input/output sides that 1/2" MPT, so this appears to be either an older or newer revision of the pump model. Which would would you guys recommend? I am looking to have both the input and output sides be reduced to a 3/8" barb.
Thanks,
-hUK
Also I have an option here, I can order it from BMW (Which I would prefer) but the input side of the housing is a 3/4" MPT which may be hard to find a fitting to reduce it to a 3/8" barb. The other fitting on the pump is the standard 1/2" MPT on the output. The one that Austin home brew sells has identical input/output sides that 1/2" MPT, so this appears to be either an older or newer revision of the pump model. Which would would you guys recommend? I am looking to have both the input and output sides be reduced to a 3/8" barb.
Thanks,
-hUK