Drilling Hole in Sanyo SR4433S for Kegerator

SSBrew - 728
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
T

tamer291

New Member
Joined
Sep 19, 2011
Messages
4
Reaction score
0
Location
Sacramento
I was wondering if there was anyone out there that has converted a Sanyo SR4433S into a kegerator. I just started and am just about to drill a hole for the tap tower. I want to avoid the lines. I can also drill a hole elsewhere other than the top if need be because my tower will actually be mounted on a bar. Any help would be appreciated.
 
Did you try the cornstarch/alcohol trick?

When I did my conversion on Sanyo 4910, I actually found that if I turned on the fridge for a little while, I could actually feel the heat from the line in the top of the fridge. I marked it off and drilled my hole 2-3" away from where I could feel the heat, just to be safe.

It came out perfect.

That being said, they ARE different models, so proceed with caution and good luck!
 

Similar threads

U
Question about drilling hole for gas line
Replies
26
Views
2K
Bassman2003
B
N
Insulation between kegerator and tap with counter
Replies
15
Views
867
Broken Crow
Broken Crow
Classywolf
Inwall tap system
Replies
2
Views
307
day_trippr
day_trippr
Yesfan
Komos/Kegland Kegerator Tower Question
Replies
1
Views
304
Broken Crow
Broken Crow
P
Kegerator leaking from inside the tower
Replies
11
Views
736
sibelman
sibelman
InkBird 300

Latest posts

Back
Top