Walmart is selling these for just over $100. Has anyone converted one to a kegerator?
I bought one for a fermentation chamber and for that use it's perfect. Holds buckets and 5 Gal. carboys no problem.
It's a 5 gallon. My 6 wouldn't fit. If by floor of the fridge you mean in front of the compressor hump then no. It's only 8.75 inches deep. Measure whatever you plan on putting in it for sure; then refer to the dimensions I posted a few posts back.
raf1919 said:would this hold 2 ball lock cornys?
Extra data for those coming across this.
The fridge is 17 in wide, 29 inches tall at it's tallest (between door and compressor hump at the back) 15.5 inches deep at its deepest, 21.5 inches tall from the compressor hump to the top, and the hump is 8.75 inches from the door. With all the hardware removed from the door and the freezer shelf taken out as well.
i just ordered this one. I'm going to put faucets on door instead to play it safe. will have to build something to elevate it higher.
There are lines in the top. They are over 0.5 inch deep though. Just be careful when cutting the hole for the tower and it should be fine. There's not much room for taps in the door in this one with standard ball locks.
241 said:Think this thing can get to lagering temps?
Nice! Do you think a 5lb tank would fit behind the kegs?
ya i would think so. i have never seen one but i have 15lb tank and mine is to tall. but there is enough room width would jsut come down to heights. but this fridge is same size maybe bigger than some of the danby or sanyos that people have successfully fit two kegs and co2.
Enter your email address to join: