Rivenin
Well-Known Member
- Joined
- Dec 13, 2010
- Messages
- 3,258
- Reaction score
- 342
Howdy!
Well i have searched on here, around the interwebs... And haven't been able to find a good answer.
Now i know a drill is a good option, but i'm trying to plan out a more permanent grain crushing area and would like a motor perma mounted to my new mill.
Only thing i can figure is take a drill apart, wire up a switch and variable resistor to control speed... however i'm not sure i want to take apart a perfectly good drill anyone have any good perma motors for a corona mill?
Well i have searched on here, around the interwebs... And haven't been able to find a good answer.
Now i know a drill is a good option, but i'm trying to plan out a more permanent grain crushing area and would like a motor perma mounted to my new mill.
Only thing i can figure is take a drill apart, wire up a switch and variable resistor to control speed... however i'm not sure i want to take apart a perfectly good drill anyone have any good perma motors for a corona mill?