Worried about drilling into the side of a Frigidaire

So I'm looking at taking the plunge into kegging. I have a Sanyo 4912 that I was considering using, but I have recently been using that for lagering and don't really want to lose that capability. Instead I would like to put 2 taps on the side of my other basement fridge, a Frigidaire FRT18IL6DML.

After doing some web research, I found some suggestions that most fridges have coils in the sides, and some that almost none do. Is there an easy way to tell? Will the alcohol/corn starch slurry trick tell me if I can safely drill? Obviously the door would be a safer option, but for asthetic and convenience reasons I'd rather put them on the side.

Thanks in advance!

Wayne

ftp://ftp.electrolux-na.com/ProdInfo_PDF/Anderson/5995469276.pdf
It looks like you coil is in the bottom of the fridge. I think you are good to go.



ftp://ftp.electrolux-na.com/ProdInfo_PDF/Anderson/241694400en.pdf
Page 14 will show you where all of the refrigeration stuff is. The project is a go!!!



http://www.frigidaire.com/products/resultspage.asp?strmodel=FRT18IL6DML
The location of the two above manuals.