TechMiller
Well-Known Member
- Joined
- Dec 24, 2012
- Messages
- 59
- Reaction score
- 4
Well I think I might have messed up and got the wrong one... I think after getting this that it is only a single controller not the Hot/Cold like the others here.
I can use a single channel for another project and even use if for my ferm cooler for now.
If any of you want to take a look at this and confirm my mistake...
The problem is, it says Heat/Cool. But it only has one set of outputs.
Model AT8001
Thanks!
I can use a single channel for another project and even use if for my ferm cooler for now.
If any of you want to take a look at this and confirm my mistake...
The problem is, it says Heat/Cool. But it only has one set of outputs.
Model AT8001
Thanks!