12thKnight
Member
I have a 3 keggle sculpture with a single march pump, propane fired.
I am interested in automating slowly, pieces at a time.
I see it going in a few small steps:
1) Get the PCB/Software and some temp probes up and running
2) Get some automated stuff going for the pump(s) to turn on and off
3) Maybe eventually get something going for the propane (solenoids/pilot lights)
Does anyone have suggestions on the cheapest and most effective ways to get started on this? I am not ready to read full-on crazy charts with every component as that will be too complex for me. I figure if I build a piece at a time it will make a lot more sense and be a lot more affordable and less frustrating.
Thanks!
I am interested in automating slowly, pieces at a time.
I see it going in a few small steps:
1) Get the PCB/Software and some temp probes up and running
2) Get some automated stuff going for the pump(s) to turn on and off
3) Maybe eventually get something going for the propane (solenoids/pilot lights)
Does anyone have suggestions on the cheapest and most effective ways to get started on this? I am not ready to read full-on crazy charts with every component as that will be too complex for me. I figure if I build a piece at a time it will make a lot more sense and be a lot more affordable and less frustrating.
Thanks!