Parts needed
1 project box- radio shack about 8 dollars, get the large one
1 compuer fan- I got one from my wife(shes an it) had 3 wires rd/blk/yel
1 bag of RV septic tubing- got mine from a northern tool store got 30 feet for 15 bucks
1 cell phone charger- all chargers have volts and amps rating on the plug part.
more amps and volts = faster fan speed
4 misc screws- go from project box to fan to hold fan on box
1 hole saw kit- I got 2 inch hose so I used 1 7/8 hole saw and for fan 1 hole saw
1 order of patience.
My Fan face was 3 inches in diameter so I used the 1 inch hole saw and cut 4 holes in like a square and filed out the edger so I had like a 4 leaf clover then flied the edges. Then on the side of the box I drilled 1 7/8 hole for the rv hose to go in. It was 2 inches but had a sprial egde on the ouside so the hose screwed into the samaller hole. I then put the fan over the cloverleaf hole and marked the holes to drill to hold the fan. I had some torx screw s that tapped the hole and tapped the cpu fan and held good. then I placed the box at the bottom of my sanyo 4912 and measured to the top if my tower. cut rv hose to length and an extra 1/2 inch. screwed 1/2 inch into project box and before top of fridge I cut a slit and fed my beer line thru to the fittings in the shanks and taped up slit. I then took the charger and routed it thru the drainage port from the outside to the inside. then cut the ends of charger and fan to expose wires. I got lucky and spliced the charger wires with the blk and yel fan wires and it pushed air thru to the project out to the end of the rv hose. plug in fan 10 min before first drink and no foam till last pour.