SpartyParty
Well-Known Member
Is it possible to not use a control box that is independent form the kettle and just use a bigger junction box on the kettle that lements runs to and wire up a PWM and SSR?
So the end result would be a larger box on the kettle with the knob for the PWM and an LED light to indicate it's powered. Then it plugs into the wall and you're set. I would use the theromometer on the kettle to indicate temp and use the dial on the PWM to adjust it up and down.
So the end result would be a larger box on the kettle with the knob for the PWM and an LED light to indicate it's powered. Then it plugs into the wall and you're set. I would use the theromometer on the kettle to indicate temp and use the dial on the PWM to adjust it up and down.