dallasdb
Well-Known Member
Have the materials for a Brutus 10 and already have the top of the frame welded.
I basically need the legs attached, 3 fittings welded onto the lower beam to run the gas through the beam and to tack weld a heat shield to where the burners will be mounted.
I'm in no rush, just want to see if a HBT member is a welder before I go and hire someone else.
Reply to this thread and we can swap contact info via PM.
Thanks!
-Dallas
I basically need the legs attached, 3 fittings welded onto the lower beam to run the gas through the beam and to tack weld a heat shield to where the burners will be mounted.
I'm in no rush, just want to see if a HBT member is a welder before I go and hire someone else.
Reply to this thread and we can swap contact info via PM.
Thanks!
-Dallas