I'm looking for Tri clamp RTD temp sensors to interface with an Auberin 2352. Brewers Hardware has these http://www.brewershardware.com/TPTC15TS7.html but I'm not getting any response from them. Any help would be appreciated.
Tri clover RTD temp sensors
- Thread starter bowhuntah
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
HenryVance3
Well-Known Member
Keep trying Darin has been great getting back to me on many occasions, I think he is just swamped right now trying to get his new dip tube valves going. He has the best quality and prices and cheap shipping in my experience.
BigBobsBrews
Well-Known Member
I buy the tri-clamp caps from derrin, then use the lathe to put a 9/16 hole through them & install weldless fitting RTD probes.
However if you don't have access to a lathe you could try these RTD temp probes with these fittings.
However if you don't have access to a lathe you could try these RTD temp probes with these fittings.
BigBobsBrews
Well-Known Member
The caps are a bit cheaper, other than that it should be the same thing
