This morning is an odd combination of lazy and exhausted, so I'm asking for smart guy help.
I have a washer hookup next to the garage where I brew and my plan is to disconnect our washer, run a 25' potable water line (already obtained) out to my brewing location and connect to my toptier. What I want is for that hose to end in another valve or spigot so I could turn on and shut off directly at the brewing stand...In other words, I want a water manifold there.
When I was at the hardware store, I noticed that the thread pitch for the common garden hose is different from every plumbing valve I could find. What type of plumbing fixture should I try to find to accept a garden hose input?
I'm going to be looking for threaded fittings, so any hints are appreciated.
I have a washer hookup next to the garage where I brew and my plan is to disconnect our washer, run a 25' potable water line (already obtained) out to my brewing location and connect to my toptier. What I want is for that hose to end in another valve or spigot so I could turn on and shut off directly at the brewing stand...In other words, I want a water manifold there.
When I was at the hardware store, I noticed that the thread pitch for the common garden hose is different from every plumbing valve I could find. What type of plumbing fixture should I try to find to accept a garden hose input?
I'm going to be looking for threaded fittings, so any hints are appreciated.