does anyone have a simple , easy to understand wiring diagram. There instructions look a little confusing. 2362 a2 pid, 5500 w element,
40 amp ssr, 3 wire 240 volt, 30 amp gfi. Thanks.
40 amp ssr, 3 wire 240 volt, 30 amp gfi. Thanks.
auber 2362 wire diagram
- Thread starter shutupjojo
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
It might help if you tell us what you are planning to do with it. 
OP
OP
It might help if you tell us what you are planning to do with it.
Its just a boil kettle. Got that pid for the manual control. The kettle is going to have its own pid and power source , breaker that is.
Thanks.
Maybe this will help:
(Click on the image to see a full scale version.)
Edit: I misread the request. I'm in do over mode.
Ok: Redrawn now for 240V only. I did not take the breakers out of the plan.
shutupjojo mentioned he is using a 30A GFCI breaker so the breakers in the wiring diagram are not needed.
........................
(Click on the image to see a full scale version.)
Edit: I misread the request. I'm in do over mode.
Ok: Redrawn now for 240V only. I did not take the breakers out of the plan.
shutupjojo mentioned he is using a 30A GFCI breaker so the breakers in the wiring diagram are not needed.
........................
My only suggestion is to use smaller sized fuses to protect the PID. They don't use anywhere near 1 amp. I have my PID, plus a stand-alone pulse width modulator, protected by the same 0.3A fuse.
OP
OP
Maybe this will help:
(Click on the image to see a full scale version.)
Edit: I misread the request. I'm in do over mode.
Ok: Redrawn now for 240V only. I did not take the breakers out of the plan.
shutupjojo mentioned he is using a 30A GFCI breaker so the breakers in the wiring diagram are not needed.
........................
Thanks P-J. I know there are a few more people that would like to see this. Your the man.
