Banjoman002
Active Member
Anybody ever build this? http://conical-fermenter.com/wp-content/uploads/TemperatureControlledBuildSetup-download.pdf Looks interesting but not sure I want to tackle it.
Rich
Rich
I'd just like to point out that the author of that manual is none other than Ron Swanson.
fastev said:Building two of these now. Marcb and I are basing ours off his 14 and 27-gallon Morebeer Ultimates, but the OP's link is basically the same thing. I just had the aluminum block made. I'll get the Peltier pads and heatsinks mounted to the blocks once I get my new milling machine set up.
Starting with 85 F water it took 4 hours to cool to 67 F. I raised the temp up to 71 F with fermwrap heater (took about 40 min), turned on cooling again and 7 hours later I terminated the test at 60 F.
Rich
Enter your email address to join: