Hey guys, I just wanted to see if I could get some opinions on a silver solder question.
Are there pros/cons to dimpling out/in?
On my keggle I pulled the dimple from the inside out, but I'm considering pulling the dimple in on my bayou classics. The following is my reasoning but I wanted to check with others before I confirmed.
Pros:
- Flame would be applied to the inside of kettle, thus keeping the kettle looking new.
- Solder would be easier to "watch" in order to stop flame once pooling. (Likely have a spotter)
Cons:
- Cut edge of stainless exposed to wort
Are there pros/cons to dimpling out/in?
On my keggle I pulled the dimple from the inside out, but I'm considering pulling the dimple in on my bayou classics. The following is my reasoning but I wanted to check with others before I confirmed.
Pros:
- Flame would be applied to the inside of kettle, thus keeping the kettle looking new.
- Solder would be easier to "watch" in order to stop flame once pooling. (Likely have a spotter)
Cons:
- Cut edge of stainless exposed to wort