FS/FT - 3x 5-1/8" Stainless Shanks for Kegerator

I downgraded to 3-1/8" shanks to make access into my kegerator easier and have three stainless shanks that were used for about six weeks to sell or trade. Located on the north shore of Boston if it matters.

Things I could use in exchange
- Perlick 525SS tap
- CO2 regulator or tank (need backup)
- Stir plate

or any cool beer making or beer gear (posters, signs, trays, etc.)

Lots of feedback on ebay as a reference.

Thanks,

Jason

How much you looking to sell them for? Is that just the thread measurement or the whole shank. Pictures?
Do they include tail pieces as well? I need them for a 2x10 collar. Do you think they will work. Thanks

I figure $40 shipped in the US to sell them outright.

They are this part - http://stores.kegconnection.com/Detail.bok?no=303 in 5-1/8" stainless @$20.89 each.

I found them too long for my collar, making it hard to easily get into the freezer with a corny, but they might work well for you depending on your setup.

Probally too long for me too but I'll measure tonight. Is that measurement from end to end

I see what you mean. My collar is only 2.25in so that would be too long. Thanks for the feedback.

alfista your mailbox is full. Are these still available?

Are these the Krome brand Stainless ones?