Kegconnection Complete Starter Kit and More Giveaway!


Home Brew Forums > Search Forums > Search Results

Showing results 1 to 25 of 26
Search took 0.01 seconds.
Search: Posts Made By: Thomsen1287
Forum: Equipment/Sanitation 06-27-2013, 07:11 PM
Replies: 6
Views: 557
Posted By Thomsen1287
Seconded on a camlock system, plus brewhardware...

Seconded on a camlock system, plus brewhardware does great service!
Forum: DIY Projects 04-10-2013, 09:16 PM
Replies: 6
Views: 1,462
Posted By Thomsen1287
The downside to copper, is that alcohol will...

The downside to copper, is that alcohol will cause the copper to patina with moderate contact, that patina is toxic, so you need to thoroughly clean before and after use
Forum: Equipment/Sanitation 04-02-2013, 10:29 PM
Replies: 55
Views: 5,751
Posted By Thomsen1287
If that is really how long it takes with your IC,...

If that is really how long it takes with your IC, then no, but I have a hard time believing that short of a time for ten gallons
Forum: Equipment/Sanitation 03-25-2013, 04:04 PM
Replies: 55
Views: 5,751
Posted By Thomsen1287
I have the blingman therminator, I gravity feed...

I have the blingman therminator, I gravity feed right now with plans to integrate a pump to recirculate, but using a simple prechiller on my water I can gravity feed wide open from boiling to ~ 70 -...
Forum: All Grain & Partial Mash Brewing 03-22-2013, 03:41 PM
Replies: 18
Views: 2,064
Posted By Thomsen1287
Actually I had a picture on my phone 109683

Actually I had a picture on my phone

109683
Forum: All Grain & Partial Mash Brewing 03-22-2013, 03:40 PM
Replies: 18
Views: 2,064
Posted By Thomsen1287
I can't post a picture right now, but I took a...

I can't post a picture right now, but I took a sanke, removed the spear, cut the bottom out and flipped it over, a valve with a 2 inch tri-clover will attach to the ferrule that the spear came out...
Forum: Equipment/Sanitation 03-21-2013, 08:35 PM
Replies: 7
Views: 979
Posted By Thomsen1287
Depending on the burner you are using you can...

Depending on the burner you are using you can still get heat on the outside of a keggle, a cheap heatshield can save your expensive thermo.
Forum: DIY Projects 03-19-2013, 03:00 PM
Replies: 10
Views: 4,520
Posted By Thomsen1287
Hey nice build JT.

Hey nice build JT.
Forum: DIY Projects 01-22-2013, 02:22 PM
Replies: 11
Views: 1,887
Posted By Thomsen1287
Genius! In the interest of full disclosure I...

Genius!

In the interest of full disclosure I may have to rip this idea myself!
Forum: DIY Projects 01-22-2013, 02:20 PM
Replies: 2
Views: 895
Posted By Thomsen1287
HLT HERMS vs Mash Tun coil

I'm getting ready to upgrade my system, if it was you, or if you had to do it all over again, would you recirculate the wort through a coil in the HLT or would you recirculate hot water through a...
Forum: General Beer Discussion 12-04-2012, 02:38 PM
Replies: 6
Views: 417
Posted By Thomsen1287
Yeah I had my first bucket blowout the other day...

Yeah I had my first bucket blowout the other day with wlp001 and a nice starter, thankfully my fermentation chamber kept it off the ceiling carpet and walls, but still a PitA to clean up, I will...
Forum: Equipment/Sanitation 11-30-2012, 09:11 PM
Replies: 8
Views: 600
Posted By Thomsen1287
No problem, I got a good chuckle!

No problem, I got a good chuckle!
Forum: Equipment/Sanitation 11-30-2012, 03:22 PM
Replies: 8
Views: 600
Posted By Thomsen1287
Not one to normally be a spelling nazi but... On...

Not one to normally be a spelling nazi but... On this case there is a large "butt" subtle difference between asses and assess....just FYI
Forum: DIY Projects 11-15-2012, 06:12 PM
Replies: 330
Views: 162,038
Posted By Thomsen1287
We did a test run on about 1000 sq ft from start...

We did a test run on about 1000 sq ft from start to finish, took us 16 hours but we learned a lot. We're moving a bit faster than that now but the equipment only goes so fast
Forum: DIY Projects 11-15-2012, 04:48 PM
Replies: 330
Views: 162,038
Posted By Thomsen1287
I can empathize on finishing the concrete, I've...

I can empathize on finishing the concrete, I've been involved with an ongoing project to refinish 25,000 sq ft of 20 year old concrete, from 30 grit all the way to 3500 all dry. We are doing it all...
Forum: Equipment/Sanitation 11-06-2012, 04:08 PM
Replies: 11
Views: 1,388
Posted By Thomsen1287
What you could do is use it as a prechiller if...

What you could do is use it as a prechiller if you need one
Forum: Home Brewing Photo Forum 11-05-2012, 05:29 PM
Replies: 25
Views: 5,460
Posted By Thomsen1287
You should never put butter or any other oil or...

You should never put butter or any other oil or fat based whatever on a burn, not only for infection reasons, it also creates a heat trapping layer of insulation. You need to wick the heat away, not...
Forum: DIY Projects 11-05-2012, 04:58 PM
Replies: 19
Views: 3,092
Posted By Thomsen1287
Brewhardware.com has some snap on heat shields in...

Brewhardware.com has some snap on heat shields in several different styles, that are worth checking out
Forum: DIY Projects 10-31-2012, 05:07 PM
Replies: 903
Views: 247,519
Posted By Thomsen1287
Can you paint high temp paint over the galvanized...

Can you paint high temp paint over the galvanized steel? Or do you have to take the galvanization off first?
Forum: Equipment/Sanitation 10-08-2012, 05:28 PM
Replies: 9
Views: 2,989
Posted By Thomsen1287
Using the large steeping basket, is it a pain in...

Using the large steeping basket, is it a pain in the ass to add more hop additions?
Forum: Equipment/Sanitation 10-05-2012, 05:42 PM
Replies: 23
Views: 2,517
Posted By Thomsen1287
There is no fluid that runs into those fins, the...

There is no fluid that runs into those fins, the fins are a heat sink they are made to pull heat off the tube running them to create a larger surface to be air cooled. It would interesting to see if...
Forum: Equipment/Sanitation 10-04-2012, 04:48 PM
Replies: 23
Views: 2,517
Posted By Thomsen1287
Plus it looks like coated copper, I'd pump some...

Plus it looks like coated copper, I'd pump some star-San into it, let it sit about 15 mins, see what comes out, could be a great hybrid chiller for your wort as well as long as its clean copper in...
Forum: Equipment/Sanitation 10-04-2012, 04:40 PM
Replies: 23
Views: 2,517
Posted By Thomsen1287
That would make one badace prechiller if your...

That would make one badace prechiller if your worried at all about sanitation issues! You could permanently mount it in a bucket with fittings, would look sweet
Forum: DIY Projects 09-26-2012, 05:41 PM
Replies: 25
Views: 2,849
Posted By Thomsen1287
With the mashtube, is it possible to mount a...

With the mashtube, is it possible to mount a manifold on the end of it if you wanted to?
Forum: Recipes/Ingredients 09-13-2012, 08:48 PM
Replies: 18
Views: 2,730
Posted By Thomsen1287
In your recipe, is that suppose to be 1/2 a...

In your recipe, is that suppose to be 1/2 a vanilla bean, or is it suppose to be a UoM in there like oz?
Showing results 1 to 25 of 26

 
Forum Jump