zymico Weld-B-Gone" Deluxe + kettle conversion kit

zymico Weld-B-Gone" Deluxe + kettle conversion kit - MrSaLTy -
4.3
 of 
5
1
7
7
$16.00 - $45.00
$33.00
$45.00
zymico
7 0

This kit converts a keg or kettle in about 5 minutes.

All you need is a 7/8" holesaw, step drill, or conduit punch and a set of channel-locks.

The valve is full port 1/2" with teflon seats.

Thread on the inside is 1/2" FPT.

The gasket is Silicone and is rated for 450F

Everything is stainless except the brass locknut, which won't touch the wort anyway.

Tags For This Thread:
None

REVIEWS(7 Total Reviews)  Add A Review

    3 of 5 | December 18, 2008 at 03:04 PM

    Price: $40.00

    Recommended? Yes

    DIY version from http://www.mcmaster.com/

    This is a work in progress. No review yet.
    5 of 5 | October 4, 2008 at 12:54 PM

    Price: $0.00

    Recommended? Yes

    This kit was exactly what I needed to get a spigot on my brew kettle. Just drill a hole and screw this bad boy in and you're good to go.
    5 of 5 | September 28, 2008 at 01:05 AM

    Price: $30.00

    Recommended? Yes

    Easy to install, comes with extra o-rings, and good instructions. All stainless steel valves. Perfect
    4 of 5 | September 9, 2008 at 03:04 PM

    Price: $16.00

    Recommended? Yes

    The product is as advertised. You dont have to weld anything, just drill a hole and insert. The only issue is that a step drill is needed for drilling a kettle or keggle, which can create issues. Works great no complaints
    5 of 5 | July 31, 2008 at 05:10 PM

    Price: $45.00

    Recommended? Yes

    I got the stainless version and put it in my 100 qt pot. It is the bomb. Worked better then I could have imagined.