disconnect stuck on corny

Brewer's Friend 728
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Pull.
Seriously, you pushed it on, it should pull off.

Did you put a grey gas connect on the Out post? Or a black liquid connect on the IN post?
 
Lift the locking collar and gently pry it off putting pressure on opposite sides and next time make sure the black disconnect on the out post and the grey disconnect on the in post;)
 
malkore said:
Pull.
Seriously, you pushed it on, it should pull off.

Did you put a grey gas connect on the Out post? Or a black liquid connect on the IN post?
Click to expand...

The most common cause of a stuck disconnect for me is as malkore says. He also outlines my most common solution.

Many cornies have indents on the plastic handles near the gas in connection. Also, the the corners of the nut on the gas connector has notches cut into it. Make sure you keep them straight.
 
There's a reason cornies used to have black o-rings and red o-rings.



And I still use them for the same reason!
 

Similar threads

B
Flow Control Disconnects
Replies
24
Views
2K
Jocky
Jocky
M
Keg identification and sealing problems
Replies
10
Views
431
mac_1103
mac_1103
Jmacd16
Partially full keg
Replies
7
Views
407
Jmacd16
Jmacd16
N
CO2 Quick Disconnect?
2
Replies
44
Views
2K
Deric
Deric
J
Quick disconnects for EVA barrier
Replies
10
Views
342
DuncB
D
Williams Brewing 300

Latest posts

Back
Top