Wables
Well-Known Member
My brew stand is 90% done, and my March pump will be here at the end of next week. Do you guys have any pictures of how you have mounted your pumps? Their web site shows no mounting info. Any help would be appreciated!
FireBrewer said:I just drilled the metal and bolted mine on.
Pic
I just recently overcame this same problem. I went to Lowe's and found large piping support brackets(2.5" and 3"). They were in the miscellaneous piping section. I had to modify them somewhat to encourage a tighter fit around the pump casing. Then simply attached them to the brew frame. The only problem that I noticed with this arrangement is that the weight of the pump was almost too much for the strength of the bracket material. They seemed to bend a little. That was corrected when I connected all the SS tubing to the inlet and outlet of the pump.
http://i201.photobucket.com/albums/aa29/natehilde/P7061459.jpg
http://i201.photobucket.com/albums/aa29/natehilde/P7071466.jpg
You can check out this thread to see if there is anything else that can help
https://www.homebrewtalk.com/showthread.php?t=31249
Enter your email address to join: