ReuFroman
Well-Known Member
To make steps easier I did a diagram of the brew day process. Basically it's my setup in a quick reference chart that I made a while ago then updated it today. I went through it a few times to make sure I had it right. This will be the process I am going for when programing for automation.
I am going rims right now, since I have that already set up. I may go herms since I already welded the kettles for it and have it in also. But this will be for a later date.
Does this look correct to you? Did I miss something?
Larger sized version
http://rfimarketing.com/Ago5Fep/brewing-process.jpg
I am going rims right now, since I have that already set up. I may go herms since I already welded the kettles for it and have it in also. But this will be for a later date.
Does this look correct to you? Did I miss something?
Larger sized version
http://rfimarketing.com/Ago5Fep/brewing-process.jpg