Brewtroller help needed!

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Mpez

Well-Known Member
Joined
Apr 30, 2009
Messages
153
Reaction score
3
Location
Seattle
I am in the process of setting up a DX1 system for my direct fire RIMs system.

I have solenoids for the HLT and MLT. I have things wired up as follows:

HLT - OUT 1 to Relay 3
MLT - OUT 2 to Relay 1

When I run a program it starts out fine. I have it set to heat strike in the HLT. When I get to Dough in it is messed up. I would expect HLT relay to be off, and MLT relay to be on. But HLT stays on.

When I get to Sacch step, the relay of HLT does this double trigger.

I have checked everything and cannot figure out why it is not firing the relay for my MLT.

Please see the video:


Any suggestions?
 
Last edited by a moderator:
Figured it out. It was something with the build I had. I changed it and it start working fine.
 
Great!

Do you mind to share some images of your build, especially on the control panel inside side?
 
Back
Top