here's a simple one, drill a hole in the cooler, insert the weldless fitting, and insert brewmometer. is this going to screw up the cooler in some way? ruin the insulation maybe?
drilling MLT cooler for thermo- good or bad?
- Thread starter SenorWanderer
- Start date
Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:
It's been done, but I can't find a thread on here. Here is a link for parts to do it.
http://www.midwestsupplies.com/products/ProdBySubCat.aspx?SubCat=870
http://www.midwestsupplies.com/products/ProdBySubCat.aspx?SubCat=870
I've drilled a cooler for one of the Thermo-thingies for an HLT. I still haven't gotten the thing to stop dripping. I didn't bother on my mashtun. I just measure temp at the beginning and end of mash. My 10 gal Rubbermaid cooler holds to a degree or two over an hour.
Similar threads
For Sale
All-grain setup - free to good home
