fifelee
Well-Known Member
Just won this on Ebay. I bought it for the temp controller, but am wondering if the heat tubes couldn't be useful.
This is some stuff I salvaged out of a heated peel tip plate assembly that came from Germany for our Comco UV Flexo press. It has an ERO Electronic Process Control Equipment Temperature Controller Model TMS431103000 Best : OSSR/10A/129 Type : 10A Prod : 9548 Lund & Sorensen A/S. It has a Gunther Solid State Relay with WG A56 D 10V Input 3-32V C Output 280V AC 10A. There are 2X 6.5" cylindrical length heater tubes rods cartridge marked HT18495 W1000 230V 270195 and 2X 9.5" cylindrical length heater tubes rods cartridges marked HT18160W1000 V230 200392. All this stuff is believed to be working, but sold as is. The display on the ERO is working, but don't have manual to set it up. It has hookup diagram on the back of the panel. Controller will work with 230V or 110V. Also don't have 230V to test cartridge heaters. Thanks for looking and check out the other auctions.
This is some stuff I salvaged out of a heated peel tip plate assembly that came from Germany for our Comco UV Flexo press. It has an ERO Electronic Process Control Equipment Temperature Controller Model TMS431103000 Best : OSSR/10A/129 Type : 10A Prod : 9548 Lund & Sorensen A/S. It has a Gunther Solid State Relay with WG A56 D 10V Input 3-32V C Output 280V AC 10A. There are 2X 6.5" cylindrical length heater tubes rods cartridge marked HT18495 W1000 230V 270195 and 2X 9.5" cylindrical length heater tubes rods cartridges marked HT18160W1000 V230 200392. All this stuff is believed to be working, but sold as is. The display on the ERO is working, but don't have manual to set it up. It has hookup diagram on the back of the panel. Controller will work with 230V or 110V. Also don't have 230V to test cartridge heaters. Thanks for looking and check out the other auctions.
