VIEW MY

zymurgist626

Gift Premium Subscription To zymurgist626

Join Date:

11-07-2008

Last Activity:

10-13-2015 10:41 PM

    ABOUT ME

  • Started in 2000... took a 3 year break and now I'm back in it like never before.
  • CJ's JPA
  • Jamil's Helles
  • Lucky Dog ESB
  • Male
  • Single

LATEST ACTIVITY

  • Posted in thread: 3-Tier Home Brewing System - HERMS - $3500 on 11-09-2015 at 12:56 AM
    btt

  • Posted in thread: 3-Tier Home Brewing System - HERMS - $3500 on 10-13-2015 at 10:41 PM
    I could pull off 15 gallons if it was a 60 min boil.... I started to craft 12 gallon batches
    with a 90 min boil.. it requires a 30 amp circuit (same as an electric dryer I believe)...

  • Posted in thread: 3-Tier Home Brewing System - HERMS - $3500 on 10-07-2015 at 11:41 AM
    Off topic but did you sell your kegging setup about 1.5 years ago? If so, I'm the one who
    bought it and think I recognize your setup from when I picked up the kegging system.I don't
    remember selling a...

  • Posted in thread: 3-Tier Home Brewing System - HERMS - $3500 on 10-05-2015 at 06:15 PM
    Absolutely, it holds a full Boil Kettle at full-boil!!! If you have never had experience with
    80/20 Extrusions and the fasteners, then you are missing out! I have run 50-60 Batches on this
    system and ...

  • Posted in thread: 3-Tier Home Brewing System - HERMS - $3500 on 10-03-2015 at 02:22 PM
    Make your own award winning beer!!!Local Pickup ONLY.... Palm Harbor, FLI AM NOT PARTING OUT
    THE SYSTEM, SO PLEASE DON'T ASKThree-Tier HomeBrew Brewery System - All Grain HERMS Systems
    (Heat Exchanger...

  • Posted in thread: Galled Thread on HLT? on 05-14-2013 at 01:05 AM
    how much torque have you applied in loosening it? It will eventually come off.As much force as
    I can put on a decent size craftman wrench. I haven't used any mechanical advantage yet... It
    doesn't mak...

  • Posted in thread: Galled Thread on HLT? on 05-14-2013 at 12:46 AM
    After testing my new Stainless HERMS HLT, I noticed a leak coming from the compression fitting.
    After removing the compression nut, I decided to back out the whole fitting from the S/S
    coupling that w...

  • Posted in thread: Blichmann conical first time use on 01-03-2013 at 12:35 AM
    I have several dozen batches under my belt w/ my Blichmann... here are my suggestions.1) Tear
    it down between batches including fittings and valves. Never assume it is clean enough w/ Star
    San.2) If y...

  • Posted in thread: Fermentation Monitoring on 11-07-2012 at 11:30 PM
    Official backer too

  • Posted in thread: Brand new HopBlocker - Blichmann - $40 on 09-02-2011 at 09:30 PM
    PM sent.

0 COMMENTS
POST A COMMENT