VIEW MY

yellowcolumbia

Gift Premium Subscription To yellowcolumbia

Join Date:

08-08-2008

Last Activity:

07-26-2012 9:52 PM

    ABOUT ME

  • Female
  • Single

LATEST ACTIVITY

  • Posted in thread: Quick disconnect temperature sensor for BCS460 on 12-20-2010 at 06:54 PM
    I'm using banana plugs on the temperature sensor leads. binding posts on the control box. Each
    post can be unscrewed from the wall plates, and installed into a drilled hole in the box.

  • Posted in thread: diy 4 tap kegerator tower... on 08-09-2010 at 09:13 PM
    Flat surfaces (like the box) can use standard straight shanks, like this: mount directly on
    round surfaces, use tower shanks: used these on 3" pvc and they fit perfectly.

  • Posted in thread: Flying cooler on 03-17-2010 at 09:27 PM
    Any rules about checking alcohol are from the airlines themselves. Those that I've checked
    require that each bottle be individually housed in styrofoam. United says, "in a Styrofoam-type
    insert that i...

  • Posted in thread: 2P-Twent-E: the new Brouwerij Boerderij Kabouter on 03-01-2010 at 08:36 PM
    What is your plan for sanitizing the immersion coil for cooling? With the way the coil is
    attached to the lid, either you will be boiling for the last few minutes with the lid on, or
    will have to use ...

  • Posted in thread: DIY draft tower? on 02-11-2010 at 01:17 PM
    how difficult is it to rig up the thermometer i have good carpentry and building skills but
    dont know very much about electrical and wiringAs wildwest said, controllers are pretty easy to
    wire, but I'...

  • Posted in thread: DIY draft tower? on 02-10-2010 at 06:22 PM
    Assuming that your build is based on a freezer, then most likely you will need some sort of
    external controller to keep what's inside from freezing. Since every freezer and its controller
    is a little ...

  • Posted in thread: DIY Randall--confused on 02-09-2010 at 02:02 PM
    For some reason I couldn't find them under pipe fittings, but was easy to find under tube
    fittings.

  • Posted in thread: Anyone Weld their Keggle Handle Holes Closed? on 02-05-2010 at 03:05 PM
    If you haven't cut the top open yet, then cut the bottom open instead. No handles to deal with,
    and depending on the keg, possibly no weep holes either. If you are using gas burners you may
    have to we...

  • Posted in thread: BCS 460 Tell me all about it. on 01-12-2010 at 04:12 PM
    It would be "nice" to have a manual panel... but if I have the BCS attached to my SSRs, I will
    still need to go into BCS to turn everything on, my manual switches could only turn them
    off.Use an on-of...

  • Posted in thread: keggle coupling welding alignment? on 12-23-2009 at 01:50 PM
    I use different thicknesses of teflon tape to adjust how far the thermo or valve can screw in.

0 COMMENTS
POST A COMMENT