Last Activity:04-18-2016 9:01 PM
2 Likes on 2 Posts
Posted in thread: Grain Mill - MM 2 vs. 3 roller? on 01-27-2014 at 12:40 AM
Have had MM3-2.0 for about 2 years now (only mill I have had) LOVE IT. Mill powered by rigid
electric drill. Here is what I do:1. Condition Grain2. Dump up to 25lbs in hopper3. Engage
drill - Mills ri...
Posted in thread: Rebel Brewer Giveaway! on 11-21-2013 at 03:08 PM
Sure would be nice...
Posted in thread: Pressure Wash a Sanke Fermenter? on 10-29-2013 at 07:12 PM
Wondering if anyone pressure washes their Sanke Fermenters? I thought I was getting them pretty
clean by soaking and scrubbing with a brush; however, near the neck where it is hard to see I
Posted in thread: MoreBeer.com Summer Giveaway! on 09-14-2013 at 03:53 AM
Posted in thread: More lighted bar signs - new and improved! on 09-08-2013 at 10:03 PM
That would be awesome!
Posted in thread: Priming in corny keg ?! on 08-12-2013 at 07:55 PM
Govner1 has it down. I have done it in the past and decided against continuing because of the
draw back of having to let it settle when moving it. I do have a kegerator, but I also use a
jockeybox a l...
Posted in thread: Brewer's Hardware 15 Gallon Stainless Steel Conical Fermenter Giveaway! on 07-29-2013 at 02:41 AM
I am IN
Posted in thread: HomeBrewTalk 2013 Big Giveaway! on 02-08-2013 at 05:16 AM
In in in
Posted in thread: Many RTD's only one controller on 02-28-2012 at 06:23 PM
I had really good luck with this unit it did take a long time to get from china though. I have
a pid, but can monitor the other 2 rtd's with the meter above. I just have the sensors hooked
up to a on...
Posted in thread: Many RTD's only one controller on 02-28-2012 at 04:18 PM
Auber Ins was very fast with getting back to me. I had just asked him the same question as the
OP. If in AUTO and you switch RTD inputs, the PID will be totally confused. If you are in
manual mode swi...