xsevenx6

Gift Premium Subscription To xsevenx6

Join Date:

10-15-2009

Last Activity:

04-29-2011 3:18 PM

    ABOUT ME

  • San Antonio
  • Female
  • Single

LATEST ACTIVITY

  • Posted in thread: Soldering Stainless steel on 05-09-2010 at 07:04 PM
    It's hard to tell from the size of the picture, but it looks like you have way too much solder
    there. It also looks like it's not really well bonded to the keg.Wow, how can you tell its not
    really wel...

  • Posted in thread: Soldering Stainless steel on 05-08-2010 at 12:21 AM
    Hey guys,I just tried brazing SS for the first time. Like many of you I'm pretty anal about
    what touches my wort so I researched Brewmoor's suggestion of Saft-Silv 56% silver solder. This
    stuff is NSF...

  • Posted in thread: Brutus 10 build on 11-07-2009 at 05:21 PM
    Where might I find someone to powdercoat my frame when constructed? Where did you get the
    components for your electronics set-up?

  • Posted in thread: "polishing your keg" is more than a clever euphemism on 11-07-2009 at 02:27 PM
    Will these guys (specifically the keg on the right) clean up as well? or do those scratches
    look too deep? pick these both up today for around $40 each.Mine were just as bad when I
    picked 'em up. I c...

  • Posted in thread: "polishing your keg" is more than a clever euphemism on 10-30-2009 at 07:04 AM
    Hey Bobby, thanks for the info. Went to Lowes to get the course, medium, and fine pads. used
    all three, then use the buffing pad by gator grit and used the black emory. Didn't bother the
    use the green...

  • Added a new Photo on 10/30/2009

  • Posted in thread: Automated HERMS system on 10-23-2009 at 09:00 PM
    This may be a stupid question as someone may have already asked, but I could not find: Would it
    be possible to run several lines with valve lines through just one pump, or would that be
    inefficient? i...

Following Stats
0 COMMENTS
POST A COMMENT