Gift Premium Subscription To wilconrad

Join Date:


Last Activity:

09-08-2016 2:46 AM

Likes Given: 105

180 Likes on 123 Posts 


  • John Deere
  • Will Conrad
  • Country, Reggae, Classic Rock
  • Male
  • Married
  • Des Moines
  • IA


  • Posted in thread: MM2 Mill powered with Garage Door Opener? on 10-07-2015 at 12:50 AM
    Awesome, nice looking build TripleHopped! You'll be glad to hear that my mill is still cranking
    away with this setup, haven't had any issues. Happy milling!

  • Posted in thread: Conical boil kettle…….. on 07-05-2015 at 05:04 PM
    Did you end up doing this? Sounds like a cool idea, curious how it went.

  • Posted in thread: Stc-1000+ on 06-15-2015 at 02:21 AM
    Agree with Alpha and Doug, your old t-shirt is doing too good a job of insulating the probe.
    Dial down the insulation, increase hysteresis and tweak delay, and you should get better
    performance. FYI, ...

  • Posted in thread: Stc-1000+ on 06-13-2015 at 03:39 PM
    That's awesome wilconrad! Are those for either 220v or 110v? It looks like they are 220.Thanks
    again!They have both (110 & 220), you might have to specify at checkout? I'm not sure as I have
    only deal...

  • Posted in thread: Stc-1000+ on 06-13-2015 at 02:07 PM
    Hi guys!I'm gonna tell it like it is right now.I know the manufacturer of the correct stc's, in
    fact I've ordered modified units (with dual probes) directly from them. You could also have
    them preflas...

  • Posted in thread: Problems with my Black Box Fermentation Temp Controller on 03-13-2015 at 09:14 PM
    Thanks for the advice and the sarcasm, both are appreciated.

  • Posted in thread: Problems with my Black Box Fermentation Temp Controller on 03-13-2015 at 11:48 AM
    Traditionally, when someone asks for help with a problem and that problem is eventually solved,
    the solution is posted for posterity.Even if that solution was something stupidly simple
    ;)Cheers!I made...

  • Posted in thread: STC-1000+ PI (the mash control firmware) on 02-22-2015 at 08:03 PM
    I have a couple of ssr's now, but never used them before, are there commercially available
    mounting pads for them etc that anyone is aware of?Yes, auber instruments is a good source:

  • Posted in thread: Online source of tri clamp hardware on 02-22-2015 at 12:11 AM
    Brewers Hardware

  • Posted in thread: Black box differences? on 01-18-2015 at 12:43 PM
    Hi Shemp, just noticed this thread. The main differences between the 1.0 & the 2.0 are a
    detachable temp probe and a more robust enclosure with mounting flanges. I also added
    screenprinted "cool" and ...

Following Stats