Welderbydaybrewerbynight

LATEST ACTIVITY

• Posted in thread: 3 gal ball lock keg on 05-17-2013 at 01:06 PM
  Will do, and again thanks for the interest.

• Posted in thread: 3 gal ball lock keg on 05-16-2013 at 11:56 PM
  I pm'ed seller within seconds of this being posted and again 3 hours later with no response..
  So idkI did see your message, but you asked me for three kegs and what price break i could give
  you on the...

• Posted in thread: 2013 Hop garden photo thread on 05-10-2013 at 11:06 PM
  2nd year cascades not doing bad at all took off like a rocket this year kinda hard to tell by
  the picture I know.121275

• Posted in thread: 3 gal ball lock keg on 05-10-2013 at 01:56 AM
  I have a 3 gal ball lock keg that I have only used once that I would like to sell. Holds
  pressure fine great condition no stickers two very small dents near the top, all new
  o-rings.Asking $70 plus sh...

• Posted in thread: kegging supplies on 01-25-2013 at 11:03 PM
  Still have the stout tap?

• Posted in thread: Cutting stainless welds on 01-24-2013 at 09:27 PM
  Cutting wheel will work fine, you will just go though blades a little faster. A plasma cutter
  will also work well if you have access to one, but will leave a rough edge to say the least.

• Posted in thread: Stir Plate on 01-15-2013 at 01:12 PM
  I would also be interested, put me in line for it.

• Posted in thread: my blow off tube went in reverse on 09-30-2012 at 07:12 PM
  Next time you cold crash remove the blow off tube or airlock and just cover with some sanitized
  aluminum foil works great never had any problems with it. Good luck with the beer I bet you can
  save it.

• Posted in thread: BierMuncher's OktoberFAST Ale (AG) on 09-30-2012 at 07:04 PM
  Brewing this right now half way though the 90 minute boil. Going to go with lager yeast though
  since I can ferment at lager temps why not. I must say that when I saw it was a biermuncher
  recipe I knew...

• Posted in thread: Refurbish or to scrap mega heat exchanger on 09-20-2012 at 02:47 AM
  Well I scraped the exchanger and used the cash to make a table for my mill (which I made all
  but the rollers) and brewing utensils. 76376